Brakes before winter: fluid, rust and manual on a slope
Three-year old brake fluid boiling at 155 instead of 230 degrees. In winter, you don't feel it, until the first long downhill.
When brake fluid absorbs 3.7 percent of water, its boiling point drops from 230 to 155 degrees, and the driver does not feel it at all. The pedal is the same, the sound is the same, the car stops. Until that winter downhill when the brake works for a minute without stopping, the fluid in the caliper boils, a bubble of steam forms, and the pedal sinks to the floor for the first time.
Winter is a tougher season for brakes than summer, just in a different way. Brakes flythey overheat on the descents; in winter, they rust, stick, freeze and work on a substrate where every meter of the stopping road costs twice. Therefore, the inspection has four points, in that order: fluid, discs and tiles, caliper guides, handbrake. The first is measured, the rest are looked at and listened to.
The fluid is changed every two years, not when it turns black
DOT 4the liquid, which the vast majority of cars have, is hygroscopic: it absorbs moisture from the air through the rubber hoses and the tank cap, approximately one to two percent per year, in humid regions and more. The problem is not the color but the boiling point. The standard prescribes a minimum of 230 degrees for dry liquid and 155 degrees for so-called wet, with 3.7 percent water — and three-year-old liquid is usually right there.
| Liquid age | About water | Boiling point DOT 4 | What does that mean? |
|---|---|---|---|
| Nova | 0% | 230°C and above | Reserve also on the mountain descent |
| 1 year | about 1.5% | approx. 195°C | Risk-free city driving |
| 2 Years | about 3% | approx. 170°C | Limit — time to replace |
| 3 and more | 3.7% and more | 155°C and below | Descent from Kopaonik or Zlatibor with a full car is a risk |
The water in the system does another thing that is not talked about: it eats away at the jaw pistons and ABS valves from the inside. Replacement of fluids in the service costs3,000 to 5,000 dinars; the new ABS unit for the Golf class car costs from 600 to over 1,000 euros, and also used with coding rarely below 250. The interval is two years regardless of mileage, and it says so in the service book of most manufacturers; in some it is only the first replacement after three years.
A check that does not require service: a brake fluid tester with two electrodes, a pen from 1,000 to 2,000 dinars from an auto-parts store, dips into the reservoir under the hood. It's a rough check, not a lab: a green light means it's fine for now, a yellow one that it's time for a service, a red one so you don't go to the mountain before replacing it.
Rust after rain is normal. Rust after a week is not
The orange layer on the discs after a night in the rain or washing issurface rust, as thick as the paint on the wall, and the tiles take it off in the first few brakes. What is worrying is the rust that remains: a ring on the outer edge of the disc, where the plate no longer reaches, or discs where the back side is brown and only the front is shiny.
This second case is typical ofrear brakes, which carry only a third of the total braking, both for hybrids and electric cars, where regenerative engine braking does almost everything, and mechanical brakes remain intact for weeks. With them, the cure is simple and free: once a week, on an empty flat street, several decisive brakes from 60 to 10 km/h, to clean the disc.
Measurements that are checked at the service center, and can also be checked through the rim:
- Tiles: new are 10 to 12 mm thick linings; below 3 mm are to be replaced, before winter, not in January.
- Disk:: the minimum thickness is stamped on the disc itself, the mark MIN TH with a number in millimeters; an edge that feels like a step with your fingernail means that the disc is worn.
- Price: a set of front discs and plates for cars of the Golf or Octavia class, with installation, about 120 to 200 euros depending on the brand of parts.
Jaw waters and road salt
Floating jaw slides on twowater, steel pins in rubber cuffs. When the cuff breaks, water with salt gets inside and the water gets stuck. The consequences are not felt immediately: one plate works, the other does not, the car pulls to the side when braking, and one wheel heats up more than the others after driving. Check it with your palm (not your fingers) on the rim after fifteen minutes of city driving — you can feel the difference without a thermometer.
Brakes fly they overheat on the descents ; in winter, they rust, stick, freeze and work on a substrate where every meter of the stopping road costs twice.
The pre-winter service should include cleaning and lubricating the lines with special brake grease; this is twenty minutes of work per axle and most services come with tile replacement at no extra charge, if required. If not requested, it is often skipped.
Parking handbrake and test
In winter, the manual has two enemies. It's the firstCordwhich rust remains tight in its sheath even after a frosty night: the car starts with the rear wheels locked. That is why a car that has been driven through slush and remains outside at minus five is not left in manual gear, but in gear (or in P with an automatic) on a straight. The other enemy isElectronic and manual.with a motor on the caliper, which does not tolerate stuck water and reports an error only when it is not released.
The test we do before each winter, in an empty parking lot, lasts five minutes:
- Real braking: 30 km/h, hands light on the steering wheel, then decisive braking to a stop. The car must stop straight; if towing, the problem is the jaws or guides on the opposite side of the towing direction.
- Pedal: with the engine switched off, press the pedal five times, then start the engine while holding it; the pedal must sink slightly. If it does not sink, the servo is to be inspected.
- Manual on the slope: On a garage ramp or a street with a visible slope, the car must only stand on the handbrake. The regulations require it to keep on a slope of 20 percent; on the ramp of the garage, which usually has 12 to 15 of them, it must not move.
- The sound: metal scraping means metal to metal: the lining is worn and the plate support plate scrapes the disc — then the test stops and the car goes for service.
None of this replaces good tires: the brake stops the wheel and the tire stops the car. If the tires are old or budget, checkwhich winter tires offer the most for moneypre nego što potrošite na diskove. And on long descents, it also helps that it works without friction —engine braking, which stores both liquid and discs.
Four jaw-saving little things
Wheels are washed in the middle of winter, not until April.Dust from the tiles mixed with salt forms a paste that waters the waters and edges of the discs. One wash of rims with a pressurized water jet in December and one in February, after which the car drives five kilometers to dry the brakes, is worth more than expensive chemistry in the spring.
Do not park wet brakes in frost.After driving through the slush, brake gently for the last kilometer to the house several times to allow the discs to dry with heat. The tile that sticks to the disc at night at minus eight peels off with a jolt, and sometimes with a piece of lining.
A rubber cuff is cheaper than a caliper.Set of cuffs and water costs about 15 to 25 euros per wheel; restored jaw three to five times more. A mechanic who shows a torn cuff when replacing the plates is the mechanic he returns to.
The liquid is not topped up with anything.DOT 4 and DOT 5.1 can be mixed, DOT 5 (silicone) never. In a tank where the level has dropped below MIN, the liquid does not refill — the level drops either because the tiles are used up and the pistons come out further, or because there is a leak somewhere. Both are for service, not for the bottle.
Questions & answers
short and to the point- How often is the brake fluid changed?
- Every two years, regardless of mileage, because DOT 4 absorbs 1-2 percent of water per year and the boiling point drops from 230 to 155 °C.
- Is it normal for discs to rust after rain?
- Surface rust after a night in the rain is normal and disappears after a few brakes. Rust remaining on the edge or back of the disc means that the tile does not work on the entire surface.
- Do you leave your car on the handbrake in winter?
- After driving through slush and frost, no; on a straight road, leave the car in gear or in P, because the cable and tiles can freeze.